5-Piece Puller Kit - Heavy Duty Bearing & Gear Puller Set for Automotive, Machinery Repair - Ideal for Mechanics, DIY Enthusiasts

Driver-5/front-clamp technology for lite utility tractor buckets allows you to work the fire out of our tool and not the other way around. Most convenient mounting of our clamp & driver-5 could be on your bucket corner hand hydraulic side and does help operator from doinking their helper. Safety-first. Clamp has 7/8” gap & is placed between bucket scraping edge 5” deep where you will drill ½” hole in your bucket for mounting. Use washers to shim-up gap between your bucket & clamp. The offset/swivel helps each t-post to hang level & swivel allows independent alignment to fencerow. Driver's latch holds each post up in driver/barrel and releases automatically. Our company has the only driver on the market that has ability to be raised up & over against your old barbwire fencerow & then press down post. (Heads-up) as each post is pressed down every now and then you’ll need to tilt your bucket or backup slightly to keep each tee post straight to prevent t-posts from kinking. After planting six t-posts you are an expert. Drop-gage is set to your tee post height. (Extremely harden ground) in worst conditions add a pipe before placing post up into driver. Your local muffler shop could cut a pipe the height of your t-posts above ground minus the length of driver barrel. Driver & pipe should touch when pressing down to your correct post height. (Add more safety rules because there are more pinch-points for you to watch out for). Pull tee posts by sliding driver barrel down over post at least three t-post notches then place 5/8 pin across bottom and lift.