Premier 1 IntelliShock 10 Energizer - 1.0 Joule Electric Fence Charger with Plug-in Kit for Livestock & Farm Security - Ideal for Cattle, Horses & Pasture Protection

Premier IntelliShock 10 Energizer This 1 joule unit automatically adjusts battery draw down by as much as 67% if the fence isn’t touching green weeds or shorted out. The need to recharge a battery is therefore much less. Common Uses A 110V AC or 12V DC electric fence energizer used mostly to keep out deer, raccoons and rabbits from garden/orchard areas. It is also used to keep in poultry, cattle, sheep, goats, horses, and guard dogs. Effective at protecting against coyotes, stray dogs, bear and fox. Should Power** 2 miles of 3 strand cattle fence3/4 mile of a 5-7 strand sheep fence10 of the 164' sheep/goat nets4-5 of the 164' poultry nets **All distances are dependent on amount of grass/weed load on the fence. Low-impedance circuitry produces a short, very strong electrical pulse designed to cope with moderate weed load. Miscellaneous Requires a grounding system. Inadequate grounding is the most common failure in an electric fence system. We recommend 3 ft. of grounding for this energizer.12V battery draw is 31-90 milliampere (mA) per hour. With this energizer a 12V, 100 ampere hour deep-cycle battery will last approximately 27 (on a weedy fence) and 80 (on a clean fence) days. (Assumes 40% drawn down between charges.)To operate as a solar energizer, run the unit as a battery unit (DC) and attach a solar panel to charge the battery. (10 watt panel recommended.) Installation Plug-In Unit The energizer can be mounted either inside or outside of a building, but not where there is risk of fire. The energizer must be mounted vertically. Protect the energizer from direct rainfall. Connect an insulated cable (stripped back 1 - 2" on ends) to the fence terminal on energizer, run the cable to the fence line and connect, or use the positive part of the wiring harness.Then run a second length of cable from the ground terminal (with ends stripped again) on the energizer to the ground rod(s), or use the negative part of the wiring harness.Secure to ground rod(s) with a clamp.Plug the energizer directly into an outlet and test fence. Do not use an extension cord as it may cause a decrease in voltage and expose the unit to the elements. Precautions: Make sure the power is turned off before working on the fence or the energizer.Never place your head or upper spine near an electrified wire. Accidental head or neck contact can occur when pushing a voltage probe into the soil. Be careful when doing so to avoid head-to-wire contact!Never attempt to step over or climb through an energized fence of any kind. Energizer Specifications 1.00 released joules 1.00 joules in moist soils 0.32 joules in dry soils Pulses per minute: 38 12V DC draw: 31-90 mA/hr 110V draw is 4.5 watt per hour Impedance type: low – pulse type A wiring harness is included to connect energizer to fence and energizer to ground rod. Energizer Only Plug-In Kit Battery Kit Add to Cart Add to Cart Add to Cart Customer Reviews 4.6 out of 5 stars 9 5.0 out of 5 stars 6 4.3 out of 5 stars 6 Price $194.00$194.00 $259.00$259.00 $229.00$229.00 IntelliShock 10 Energizer ✓ ✓ ✓ (1) Ground Rod no data 3 ft 3 ft (1) Ground Rod Clamp no data ✓ no data (1) Hanging Nut no data no data ✓ MaxiShock Insulated Cable no data 100' Roll no data Wiring Harness ✓ no data ✓ Digital Tester for Fences & Batteries no data ✓ ✓