Driver-4/Puller Kit - Heavy Duty Automotive Tool Set for Wheel Bearing & Hub Removal | Perfect for DIY Car Repairs & Professional Mechanics

Driver-4 kit designed for tractor buckets to allow your utility tractor to work the fire out of our tool and not the other way around. Most convenient mounting of clamp/driver-4 is on bucket corner hand hydraulics side and does help keep operator from doinking their helper. Clamp has 7/8” gap to be placed between bucket scraping edge 5” deep where you will drill ½” hole in your bucket for mounting. We sent washers to shim up gap between your bucket & clamp. Driver offset/swivel helps each t-post to hang level & swivel allows independent alignment to fencerow. Driver-4 barrel is 80% open to allow twisted beaten up posts in and out of driver barrel. Gripper is mounted on the bottom of barrel along with our t-post puller. No need to put a gorilla grip to each post & unsnap gripper’s just before pressing down that saves on the old wear and tear. Every now and then tilt your bucket or backup slightly when pressing down keeping each post level to stop bowing & kinking. After you planted 6 t-posts you are an expert. Only driver on the market that has ability to be raised up over and up against your old barbwire fencerow then press down tee post. (Extremely harden ground) in worst conditions add a pipe before placing post up into driver. Your local muffler shop could cut a pipe the height of your t-posts above ground minus the length of driver barrel. Driver & pipe should touch when pressing down to your correct height. Pull tee posts by sliding driver barrel down over post at least three t-post notches then place 5/8 pin across bottom and lift. Please consider what took you all day of working hard to accomplish by hand now takes an hour of just being there.